usefor-article-09 February 2003
[< Prev]
[TOC] [ Next >]
6.15. Supersedes
The Supersedes-header contains a message identifier specifying an
article to be superseded upon the arrival of this one. The specified
article MUST be treated as though a "cancel" control message had
arrived for the article (but observe that a site MAY choose not to
honour a "cancel" message, especially if its authenticity is in
doubt). The content syntax makes use of syntax defined in [RFC 2822],
subject to the same revisions as in 5.3.
header =/ Supersedes-header
Supersedes-header = "Supersedes" ":" SP Supersedes-content
Supersedes-content = [CFWS] msg-id [CFWS]
NOTE: There is no "c" in "Supersedes".
NOTE: The Supersedes-header defined here has no connection with
the Supersedes-header that sometimes appears in Email messages
converted from X.400 according to [RFC 2156]; in particular, the
syntax here permits only one msg-id in contrast to the multiple
msg-ids in that Email version.
Thus when an article contains a Supersedes-header, the old article
mentioned SHOULD be withdrawn from circulation or access, as in a
cancel message (7.3), and the new article inserted into the system as
any other new article would have been.
Whatever security or authentication checks are normally applied to a
Control cancel message (or may be prescribed for such messages by
some extension to this standard - see the remarks in 7.1 and 7.3)
MUST also be applied to an article with a Supersedes-header. In the
event of the failure of such checks, the article SHOULD be discarded,
or at most stored as an ordinary article.
[< Prev]
[TOC] [ Next >]
#Diff to first older
--- ../usefor-article-08/Supersedes.out August 2002
+++ ../usefor-article-09/Supersedes.out February 2003
@@ -10,7 +10,6 @@
header =/ Supersedes-header
Supersedes-header = "Supersedes" ":" SP Supersedes-content
- *( ";" other-parameter )
Supersedes-content = [CFWS] msg-id [CFWS]
NOTE: There is no "c" in "Supersedes".