usefor-article-11 June 2003

8.2.2.  Procedure to be followed by Injecting Agents

   A injecting agent receives proto-articles from posting and followup
   agents. It verifies them, adds headers where required and then either
   forwards them to a moderator or injects them by passing them to
   serving or relaying agents.

   If an injecting agent receives an otherwise valid article that has
   already been injected it SHOULD either act as if it is a relaying
   agent or else pass the article on to a relaying agent completely
   unaltered. Exceptionally, it MAY reinject the article, perhaps as a
   part of some complex gatewaying process (in which case it will add a
   second '%' path-delimiter to the Path-header).  It MUST NOT forward
   an already injected article to a moderator.

   An injecting agent processes articles as follows:

   1. It MUST remove any Injector-Info- or Complaints-To-header already
      present (though it might be useful to copy them to suitable X-
      headers). It SHOULD likewise remove any NNTP-Posting-Host or other
      undocumented tracing header.

   2. It SHOULD verify that the article is from a trusted source.
      However, it MAY allow articles in which headers contain "forged"
      email addresses, that is, addresses which are not valid for the
      known and trusted source, especially if they end in ".invalid".

   3. It MUST reject any article whose Date-header is more than 24 hours
      into the past or into the future (cf. 5.1).

   4. It MUST reject any article that does not have the correct
      mandatory headers for a proto-article (5 and 8.2.1) present, or
      which contains any header that does not have syntactically legal
      contents.  It SHOULD reject any article which contains any header
      deprecated for Netnews (4.2.1).

   5. If the article is rejected (for reasons given above, or for other
      formatting errors or matters of site policy) the posting agent
      SHOULD be informed (such as via an NNTP 44x response code) that
      posting has failed and the article MUST NOT then be processed
      further.

   6. The Message-ID and Date-headers (and their contents) MUST be added
      when not already present.

   7. A Path-header with a tail-entry (5.6.3) MUST be correctly added if
      not already present (except that it SHOULD NOT be added if the
      article is to be forwarded to a moderator).

   8. The path-identity of the injecting agent with a '%' path-delimiter
      (5.6.2) MUST be prepended to the Path-header; moreover, that
      path-identity MUST be an FQDN mailable address (5.6.2).

   9. An Injector-Info-header (6.19) SHOULD be added, identifying the
      trusted source of the article, and a suitable Complaints-To-header
      (6.20) MAY be added (except that these two headers MUST NOT be
      added if the article is to be forwarded to a moderator).

   10.The injecting agent MUST NOT alter the body of the article in any
      way. It MAY add other headers not already provided by the poster,
      but SHOULD NOT alter, delete, or reorder any existing header, with
      the specific exception of "tracing" headers such as Injector-Info
      and Complaints-To, which are to be removed as already mentioned.

   11.If the Newsgroups-header contains no moderated groups, or if it
      contains an Approved-header, the injecting agent forwards the
      article to one or more relaying or serving agents.



   12.Otherwise, when the Newsgroups-header contains one or more
      moderated groups and the article does NOT contain an Approved-
      header, the injecting agent MUST forward it to the moderator of
      the first (leftmost) moderated group listed in the Newsgroups-
      header via email. There are two possibilities for doing this:

      (a)  The complete article is encapsulated (headers and all) within
 the email, preferably using the Content-Type
 "application/news-transmission" (6.21.6.1) with any usage
 parameter set to "moderate". Moreover, there SHOULD NOT be
 more than one encapsulated article within the one email.
 This method has the advantage of removing any possible
 conflict between Netnews and Email headers, or of changes to
 those headers during transport through email.

      (b)  The article is sent as an email as it stands, with the
 addition of such extra headers (e.g. a To-header) as are
 necessary for an email.

      Although both of these methods have seen use in the past, the
      preponderance of current usage on Usenet has been for method (b)
      and many moderators are ill-prepared to deal with method (a).
      Therefore, method (a) SHOULD NOT be used until such time as the
      majority of moderators are able to accept it.

   13.This standard does not prescribe how the email address of the
      moderator is to be determined, that being a matter of policy to be
      arranged by the agency responsible for the oversight of each
      hierarchy. Nevertheless, there do exist various agents worldwide
      which provide the service of forwarding to moderators, and the
      address to use with them is obtained as follows:

      (a)  Each '.' in the newsgroup-name is replaced with a '-'.

      (b)  The result of these operations is used as the local-part of
 the mailbox of the agent. For example, articles intended for
 "news.announce.important" would be emailed to "news-
 announce-important@forwardingagent.example".

--- ../usefor-article-10/Procedure_to_be_followed_by_Injecting_Agents.out          April 2003
+++ ../usefor-article-11/Procedure_to_be_followed_by_Injecting_Agents.out          June 2003
@@ -34,8 +34,6 @@
       contents.  It SHOULD reject any article which contains any header
       deprecated for Netnews (4.2.1).
 
-
-
    5. If the article is rejected (for reasons given above, or for other
       formatting errors or matters of site policy) the posting agent
       SHOULD be informed (such as via an NNTP 44x response code) that
@@ -64,17 +62,11 @@
       the specific exception of "tracing" headers such as Injector-Info
       and Complaints-To, which are to be removed as already mentioned.
 
-        NOTE: The addition of non-mandatory headers by the injecting
-        agent may alter the posting agent's preferred presentation of
-        information. In particular, adding a Sender-header that exposes
-        a sender's mailbox has privacy implications; where the main or
-        only purpose for doing so is as tracing information, it is
-        preferable to use instead one of the options provided for the
-        Injector-Info header (6.19.1).
-
    11.If the Newsgroups-header contains no moderated groups, or if it
       contains an Approved-header, the injecting agent forwards the
       article to one or more relaying or serving agents.
+
+
 
    12.Otherwise, when the Newsgroups-header contains one or more
       moderated groups and the article does NOT contain an Approved-